H3C Technologies H3C SecPath F1000-E - Manual (Page 242)

19
To do… Use the command… Remarks
Establish an FTP
connection
ftp [ server-address [ service-port ]
[ [ vpn-instance
vpn-instance-name ] | [ source
{ interface interface-type
interface-number | ip
source-ip-address } ] ] ]
Establish an FTP
connection in an IPv6
network environment
ftp ipv6 [ server-address
[ service-port ] [ source ipv6
source-ipv6-address ] [ -i
interface-type interface-number ] ]
Upload a file on the
client to the remote FTP
server
put localfile [ remotefile ]
Download a file from a
remote FTP server and
save it
get remotefile [ localfile ]
Uploading
the
security
log file to
the FTP
server
All other operations
supported by the device
acting as an FTP client
Refer to the related part in the FTP
and TFTP Configuration in the IP
Services Volume.
Optional
The ftp commands are
available in user view; the other
commands are available in FTP
client view.
Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the user’s input is interrupted by system output
such as log, trap, or debugging information, then after the completion of system output the system will
display a command line prompt (a prompt in command editing mode, or a [Y/N] string in interaction
mode) and your input so far.
This command is used in the case that your input is interrupted by a large amount of system output. With
this feature enabled, you can continue your operations from where you were stopped.
Follow these steps to enable synchronous information output:
To do… Use the command… Remarks
Enter system view system-view —
Enable synchronous information
output
info-center synchronous
Required
Disabled by default
NOTE:
•
If system information, such as log information, is output before you input any information under the
current command line prompt, the system will not display the command line prompt after the system
information output.
• If system information is output when you are inputting some interactive information (non Y/N
confirmation information), then after the system information output, the system will not display the
command line prompt but your previous input in a new line.