H3C Technologies H3C SecPath F1000-E - Manual (Page 257)

5
To do… Use the command… Remarks
Set the size of the history command
buffer of the user interface history-command max-size
size-value
Optional
The history buffer can store 10
commands by default.
Return to user view return ––
Lock the user interface to prevent
unauthorized users from using this
interface
lock
Optional
Disabled by default.
NOTE:
The system supports two types of terminal display: ANSI and VT100. If the terminal display of the device
and the client (for example, hyper terminal or telnet terminal) is inconsistent or is set to ANSI, and if the
total number of the characters of the command line that is being used exceeds 80, anomalies such as
cursor corruption or abnormal display of the terminal display may occur on the client. Therefore, you are
recommended to set the display type of both the device and the client to VT100.
Configuring Modem Attributes
NOTE:
The modem attributes configuration is applicable to AUX ports in flow mode. The modem attribute
configuration is not applicable to console ports.
In the event of dial-in through a modem into an asynchronous interface, manage and configure the
modem-concerned parameters in user interface view.
Follow these steps to configure the modem attributes:
To do… Use the command… Remarks
Enter system view system-view ––
Enter user interface view
user-interface { first-num1
[ last-num1 ] | { aux | vty }
first-num2 [ last-num2 ] }
––
Set the interval for a user from
hookoff to dial-up when dial-in
connection is established
modem timer answer time
Optional
60 seconds by default
Enable auto answer for the modem modem auto-answer
Optional
Manual answer by default
Enable the modem to dial in, dial
out or both modem { both | call-in |
call-out } Optional
Disabled by default
Configuring auto-execute command
The system automatically execute a command when a user logs in to the user interface where
auto-execute command is configured. The system tears down the user connection after the