H3C Technologies H3C SecPath F1000-E - Manual (Page 20)

19
Enabling the Trap Function for VRRP
When the trap function is enabled for VRRP, VRRP generates traps with severity level errors to report its
key events. The traps are sent to the information center of the device, where you can configure whether
to output the trap information and the output destination. For information center configurations, see
Information Center Configuration in the System Volume.
Follow these steps to enable the trap function for VRRP:
To do… Use the command… Remarks
Enter system view system-view —
Enable the trap function for VRRP
snmp-agent trap enable
vrrp [ authfailure |
newmaster ]
Optional
Enabled by default.
NOTE:
For more information about the snmp-agent trap enable vrrp command, see command snmp-agent trap
enable in
SNMP Commands in the System Volume.
Displaying and Maintaining VRRP for IPv4
To do… Use the command… Remarks
Display VRRP group status
display vrrp [ verbose ]
[ interface interface-type
interface-number [ vrid
virtual-router-id ] ]
Available in any view
Display VRRP group statistics
display vrrp statistics
[ interface interface-type
interface-number [ vrid
virtual-router-id ] ]
Available in any view
Clear VRRP group statistics
reset vrrp statistics
[ interface interface-type
interface-number [ vrid
virtual-router-id ] ]
Available in user view
Configuring VRRP for IPv6
VRRP for IPv6 Configuration Task List
Complete these tasks to configure VRRP for IPv6:
Task Remarks
Mapping a Virtual IPv6 Address to a MAC Address
Optional
When VRRP works in load balancing
mode, the mapping between a virtual
IP address and a MAC address can
be configured but is not effective.