H3C Technologies H3C SecPath F1000-E - Manual (Page 31)

30
Figure 12 Network diagram for multiple VRRP groups configuration
Configuration procedure
Step1 Configure Device A
system-view
[DeviceA] interface gigabitethernet 0/1
[DeviceA-GigabitEthernet0/1] ip address 202.38.160.1 255.255.255.0
# Create VRRP group 1 and configure its virtual IP address as 202.38.160.111.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 202.38.160.111
# Set the priority of Device A in VRRP group 1 to 110.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 priority 110
# Create VRRP group 2 and configure its virtual IP address as 202.38.160.112.
[DeviceA-GigabitEthernet0/1] vrrp vrid 2 virtual-ip 202.38.160.112
Step2 Configure Device B
system-view
[DeviceB] interface gigabitethernet 0/1
[DeviceB-GigabitEthernet0/1] ip address 202.38.160.2 255.255.255.0
# Create VRRP group 1 and configure its virtual IP address as 202.38.160.111.
[DeviceB-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 202.38.160.111
# Create VRRP group 2 and configure its virtual IP address as 202.38.160.112.
[DeviceB-GigabitEthernet0/1] vrrp vrid 2 virtual-ip 202.38.160.112
# Set the priority of router B in VRRP group 2 to 110.
[DeviceB-GigabitEthernet0/1] vrrp vrid 2 priority 110
Table 1
8Verify the configuration
To verify your configuration, use the display vrrp verbose command.
# Display detailed information of the VRRP group on Device A.
[DeviceA-GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information: