H3C Technologies H3C SecPath F1000-E - Manual (Page 57)

4
To do… Use the command… Remarks
time timeID { one-off |
repeating } at time1
[ month-date month-day |
week-day week-daylist ]
command command
configure the time to execute the
commands in the task
time timeID { one-off |
repeating } delay time2
command command
Use any of the commands.
NOTE:
•
Only one view can be specified for a task, which means all commands in the task are executed in the
same specified view. If different views are specified by executing the view
view-name command
repeatedly, only the last configuration takes effect.
• The view must be currently supported by the system, with its name specified using its complete format but
not an abbreviation. Most commonly used view names include: monitor for user view, system for system
view, GigabitEtherent x/x for Ethernet interface view, and Vlan-interfacex for VLAN interface view.
• timeID is used to uniquely identify the binding between a command and its execution time. A scheduled
task can contain up to 10 commands.
• The command specified by the command command argument must be a command that can be
executed in the view specified by the view view-name command; otherwise this command cannot be
automatically executed. Therefore, ensure the correctness of the configuration.
Upgrading Device Software
Device Software Overview
Device software comprises the Boot ROM program and the system boot file. After powered on, the device
runs the Boot ROM program, initializes the hardware, and displays the hardware information. Then the
device runs the boot file. The boot file provides drivers and adaption for hardware, and implements
service features. The Boot ROM program and system boot file are required for the startup and running of
a device. Figure 1 illustrates their relationship.