H3C Technologies H3C SecPath F1000-E User Manual
Page 85

19
To do…
Use the command…
Remarks
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address must be
consistent with that of the existing
listening service on the NQA
server.
Configure the destination port for a
test operation
destination port port-number
Required
By default, no destination port
number is configured for a test
operation.
The destination port must be
consistent with that of the existing
listening service on the NQA
server.
Configure the codec type
codec-type { g711a | g711u
| g729a }
Optional
By default, the codec type is
G.711 A-law.
Configure the advantage factor for
calculating MOS and ICPIF values advantage-factor factor
Optional
By default, the advantage factor is
0.
Specify the source IP address for
the requests in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, the test will fail.
Specify the source port number for
the requests in a test operation
source port port-number
Optional
By default, no source port number
is specified.
Configure the size of a probe
packet to be sent
data-size size
Optional
By default, the probe packet size
depends on the codec type. The
default packet size is 172 bytes for
G.711A-law and G.711 μ-law
codec type, and is 32 bytes for
G.729 A-law codec type.
Configure the filler string of a
probe packet sent
data-fill string
Optional
By default, the filler string of a
probe packet is the hexadecimal
number
00010203040506070809.
Configure the number of packets
sent in a voice probe
probe packet-number
packet-number
Optional
1000 by default.