H3C Technologies H3C SecPath F1000-E - Manual (Page 83)

17
To do… Use the command… Remarks
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as UDP
echo and enter test type view
type udp-echo Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination address must be
the IP address of the listening
service configured on the NQA
server.
Configure the destination port destination port port-number
Required
By default, no destination port
number is configured for a test
operation.
The destination port number must
be the port number of the listening
service configured on the NQA
server.
Configure the size of probe
packets sent
data-size size
Optional
100 bytes by default.
Configure the filler string of a
probe packet sent
data-fill string
Optional
By default, the filler string of a
probe packet is the hexadecimal
number
00010203040506070809.
Specify a source port number for a
probe request in a test operation
source port port-number
Optional
By default, no source port number
is specified.
Configure the source IP address of
a probe request in a test operation source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
See Configuring Optional
Parameters Common to an NQA
Test Group
Optional
Configuring a Voice Test