H3C Technologies H3C SecPath F1000-E - Manual (Page 236)

13
To do… Use the command… Remarks
Configure the channel through
which system information can be
output to the log buffer and specify
the buffer size
info-center logbuffer
[ channel { channel-number |
channel-name } | size buffersize ]
*
Optional
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer)
and the default buffer size is 512.
Configure the output rules of the
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to
Default Output Rules of
System .
Configure the format of the time
stamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is
date by default.
Outputting System Information to the SNMP Module
NOTE:
The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network management
station (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For details, refer to SNMP
Configuration in the System Volume.
Follow these steps to configure to output system information to the SNMP module:
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
Refer to
Table 2 for default channel
names.
Configure the channel through
which system information can be
output to the SNMP module
info-center snmp channel
{ channel-number |
channel-name }
Optional
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).