H3C Technologies H3C SecPath F1000-E - Manual (Page 203)

9
[System] header shell %Welcome to H3C!%
• Multiple-line input mode (method I):
system-view
[System] header shell
Please input banner content, and quit with the character '%'.
Welcome to H3C!
%
• Multiple-line input mode (method II):
system-view
[System] header shell W
Please input banner content, and quit with the character 'W'.
Welcome to H3C!
W
Configuring CLI Hotkeys
Follow these steps to configure CLI hotkeys:
To do… Use the command… Remarks
Enter system view system-view —
Configure CLI hotkeys
hotkey { CTRL_G | CTRL_L |
CTRL_O | CTRL_T | CTRL_U }
command
Optional
The Ctrl+G, Ctrl+L and Ctrl+O
hotkeys are specified at the CLI by
default.
Display hotkeys display hotkey
Available in any view. See Table 2
for hotkeys reserved by the system.
NOTE:
By default, the Ctrl+G, Ctrl+L and Ctrl+O hotkeys are configured at the CLI and the Ctrl+T and Ctrl+U
commands are NULL.
• Ctrl+G corresponds to the display current-configuration command.
• Ctrl+L corresponds to the display ip routing-table command.
• Ctrl+O corresponds to the undo debugging all command.
Table 2 Hotkeys reserved by the system
Hotkey Function
Ctrl+A Moves the cursor to the beginning of the current line.
Ctrl+B Moves the cursor one character to the left.
Ctrl+C Stops performing a command.
Ctrl+D Deletes the character at the current cursor position.
Ctrl+E Moves the cursor to the end of the current line.
Ctrl+F Moves the cursor one character to the right.
Ctrl+H Deletes the character to the left of the cursor.