H3C Technologies H3C SecPath F1000-E - Manual (Page 235)

12
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
Refer to
Table 2 for default channel
names.
Configure the channel through
which system information can be
output to the trap buffer and
specify the buffer size
info-center trapbuffer
[ channel { channel-number |
channel-name } | size buffersize ]
*
Optional
By default, system information is
output to the trap buffer through
channel 3 (known as trapbuffer)
and the default buffer size is 256.
Configure the output rules of the
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to
Default Output Rules of
System .
Configure the format of the time
stamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is
date by default.
Outputting System Information to the Log Buffer
NOTE:
You can configure to output log, trap, and debugging information to the log buffer, but the log buffer
receives the log and debugging information only, and discards the trap information.
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default.
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
Refer to
Table 2 for default channel
names.