H3C Technologies H3C SecPath F1000-E - Manual (Page 227)

4
Information
channel
number
Default
channel name
Default output destination Description
6 channel6 Web interface Receives log information.
7 channel7 Not specified
Receives log, trap, and debugging
information.
8 channel8 Not specified
Receives log, trap, and debugging
information.
9 channel9 Log file
Receives log, trap, and debugging
information.
NOTE:
Configurations for the eight output destinations function independently and take effect only after the
information center is enabled.
Outputting System Information by Source Module
The system is composed of a variety of protocol modules, board drivers, and configuration modules. The
system information can be classified, filtered, and output according to source modules. You can use the
info-center source ? command to view the supported information source modules.
Default Output Rules of System Information
The default output rules define the source modules allowed to output information on each output
destination, the output information type, and the output information level as shown in
Table 3 , which
indicates that by default and in terms of all modules:
• All log information is allowed to be output to the Web interface and log file; log information with
severity level equal to or higher than informational is allowed to be output to the log host; log
information with severity level equal to or higher than informational is allowed to be output to the
console, monitor terminal, and log buffer; log information is not allowed to be output to the trap
buffer and the SNMP module.
• All trap information is allowed to be output to the console, monitor terminal, log host, Web interface,
and log file; trap information with severity level equal to or higher than informational is allowed to
be output to the trap buffer and SNMP module; trap information is not allowed to be output to the
log buffer.
• All debugging information is allowed to be output to the console and monitor terminal; debugging
information is not allowed to be output to the log host, trap buffer, log buffer, the SNMP module,
Web interface, and log file.
Table 3 Default output rules for different output destinations
LOG TRAP DEBUG Output
destinatio
n
Modules
allowed
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Console
default (all
modules)
Enabled
Informatio
nal
Enabled Debug Enabled Debug