H3C Technologies H3C SecPath F1000-E - Manual (Page 324)

7
To do… Use the command… Remarks
Load the patch file from the storage
medium (such as the CF card) to
the memory patch area
patch load Required
Activating Patches
After you activate a patch, the patch will take effect and is in the test-run stage. After the device is reset
or rebooted, the patch becomes invalid.
If you find that an ACTIVE patch is of some problem, reboot the device to deactivate the patch, so as to
avoid a series of running faults resulting from patch error.
Follow these steps to activate patches:
To do… Use the command… Remarks
Enter system view system-view —
Activate the specified patches patch active patch-number Required
Confirming Running Patches
After you confirm the running of a patch, the patch state becomes RUNNING, and the patch is in the
normal running stage. After the device is reset or rebooted, the patch is still valid.
Follow these steps to confirm the running of the patches:
To do… Use the command… Remarks
Enter system view system-view —
Confirm the running of the
specified patches
patch run patch-number Required
NOTE:
This operation is applicable to patches in the ACTIVE state only.
One-Step Patch Uninstallation
Use the undo patch install command to uninstall all patches. The patches then turn to the IDLE state.
This equals execution of the commands patch deactive and patch delete.
Follow these steps to uninstall the patches in one step:
To do… Use the command… Remarks
Enter system view system-view —
Uninstall the patches undo patch install Required