H3C Technologies H3C SecPath F1000-E User Manual
Page 77
11
To do…
Use the command…
Remarks
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a test
operation is the IP address of the
FTP server.
Configure the source IP address of
a probe request
source ip ip-address
Required
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, the test will fail.
Configure the operation type
operation { get | put }
Optional
By default, the operation type for
the FTP is get, which means
obtaining files from the FTP server.
Configure a login username
username name
Required
By default, no login username is
configured.
Configure a login password
password password
Required
By default, no login password is
configured.
Specify a file to be transferred
between the FTP server and the FTP
client
filename file-name
Required
By default, no file is specified.
Set the data transmission mode for
FTP tests
mode { active | passive }
Optional
active by default.
Configure common optional
parameters
Optional
NOTE:
•
When you execute the put command, a file
file-name with fixed size and content is created on the FTP
server. When you execute the get command, the device does not save the files obtained from the FTP
server.
•
When you execute the get command, the FTP test cannot succeed if a file named
file-name does not exist
on the FTP server.
•
When you execute the get command, use a file with a smaller size because a big file may result in test
failure due to timeout, or may affect other services because of occupying too much network bandwidth.