H3C Technologies H3C SecPath F1000-E - Manual (Page 273)

2
Protocols and Standards
RFC 1945: Hypertext Transfer Protocol – HTTP/1.0
Enabling the HTTP Service
The device can act as the HTTP server and the users can access and control the device through the Web
function only after the HTTP service is enabled.
Follow these steps to enable the HTTP service:
To do… Use the command… Remarks
Enter system view system-view —
Enable the HTTP service ip http enable Required
Configuring the Port Number of the HTTP Service
Configuration of the port number of the HTTP service can reduce the attacks from illegal users on the
HTTP service.
Follow these steps to configure the port number of the HTTP service:
To do… Use the command… Remarks
Enter system view system-view —
Configure the port number of the
HTTP service
ip http port port-number
Required
By default, the port number of the
HTTP service is 80.
NOTE:
If you execute the ip http port command for multiple times, the last configured port number is used.
Associating the HTTP Service with an ACL
By associating the HTTP service with an ACL, only the clients that pass ACL filtering are allowed to access
the device.
Follow these steps to associate the HTTP service with an ACL:
To do… Use the command… Remarks
Enters system view system-view —