H3C Technologies H3C SecPath F1000-E - Manual (Page 160)

10
To do… Use the command… Remarks
Display SNMP agent group
information display snmp-agent group
[ group-name ]
Display basic information of the
trap queue display snmp-agent trap
queue
Display the modules that can send
traps and whether their trap
sending is enabled or not
display snmp-agent trap-list
Display SNMPv3 agent user
information
display snmp-agent
usm-user [ engineid engineid |
username user-name | group
group-name ] *
Display SNMPv1 or v2c agent
community information display snmp-agent
community [ read | write ]
Display MIB view information for
an SNMP agent
display snmp-agent
mib-view [ exclude | include
| viewname view-name ]
SNMPv1/SNMPv2c Configuration Example
Network requirements
• As shown in Figure 4 , the NMS connects to the agent through an Ethernet.
• The IP address of the NMS is 1.1.1.2/24.
• The IP address of the agent is 1.1.1.1/24.
• The NMS monitors and manages the agent using SNMPv1 or SNMPv2c. The agent reports errors
or faults to the NMS.
Figure 4 Network diagram for SNMPv1/v2c
Configuration procedure
Step1 Configuring the SNMP agent
# Configure the IP address of the agent as 1.1.1.1/24 and make sure that there is a route between the
agent and the NMS. (The configuration procedure is omitted here)
# Configure the SNMP basic information, including the version and community name.
system-view
[Sysname] snmp-agent sys-info version v1 v2c
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
# Configure the contact person and physical location information of the switch.