Configuring a dlsw test, Configuration prerequisites – H3C Technologies H3C SecPath F1000-E User Manual
Page 86
20
To do…
Use the command…
Remarks
Configure the interval for sending
packets in a voice probe
probe packet-interval
packet-interval
Optional
20 milliseconds by default.
Configure the timeout for waiting
for a response in a voice test
probe packet-timeout
packet-timeout
Optional
5000 milliseconds by default.
Configure common optional
parameters
Optional
NOTE:
Only one probe can be made in one voice test, and the number of probe packets sent in each probe
depends on the configuration of the probe packet-number command.
Configuring a DLSw Test
A DLSw test is used to test the response time of the DLSw device.
Configuration prerequisites
Enable the DLSw function on the peer device before DLSw test.
Configuring a DLSw test
Follow these steps to configure a DLSw test:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as DLSw
and enter test type view
type dlsw
Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Configure the source IP address of
a probe request in a test operation source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
Optional