Configuring an http test, Configuration prerequisites – H3C Technologies H3C SecPath F1000-E User Manual
Page 78
12
Configuring an HTTP Test
An HTTP test is used to test the connection between the NQA client and a specified HTTP server and the
time required to obtain data from the HTTP server, thus detecting the connectivity and performance of the
HTTP server.
Configuration prerequisites
Before performing an HTTP test, configure the HTTP server.
Configuring an HTTP test
Follow these steps to configure an HTTP test:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as HTTP
and enter test type view
type http
Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a test
operation is the IP address of the
HTTP server.
Configure the source IP address of
a probe request
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, the test will fail.
Configure the operation type
operation { get | post }
Optional
By default, the operation type for
the HTTP is get, which means
obtaining data from the HTTP
server.
Configure the website that an HTTP
test visits
url url
Required
Configure the HTTP version used in
the HTTP test
http-version v1.0
Optional
By default, HTTP 1.0 is used in an
HTTP test.
Configure common optional
parameters
Optional