Fluke Biomedical medTester 5000C - Manual (Page 75)

Biomedical Test System
Autosequences
5
5-5
SAFETY AUTOSEQUENCES
TEMPMON Temperature
Monitor
TOOLBOX
F2
TEMPMON
F4
A18
HUMMON Humidity
Monitor
TOOLBOX
F2
HUMMON
F5
A19
Autosequence Device Prompts
After you select an autosequence, medTester prompts you to enter the
following information for the device that you want to test. Entry information
can be any combination of alpha or numeric characters. After each entry press
the
ENT (Enter) key.
1. OP CODE—This is the operating code for the person doing the
testing. This code can consist of a maximum of three characters
which can be entered from the medTester keyboard. An example
of an operator code could be a person's initials or employee
number. The previous operator’s code, if any, will appear. If the
current operator has not changed from previous use, press the
ENT key.
2. TYPE—Enter the device name, code, or other descriptor for the
equipment under test. This entry can be a maximum of 16
characters.
3. MANF—Enter the name of the device manufacturer, 16
characters maximum.
4. LOC—Type in the location of the device, 16 characters
maximum. The previous location, if any, will appear. If this occurs
and is the desired location, press the
ENT key.
5. MODEL—Enter the device model number, 16 characters
maximum.
6. SERIAL #—Type the device serial number, again 16 characters
maximum.
7. CONTROL #—Enter a control number with a maximum of 16
characters.
8. PHYSICAL INSPECTION—You have two physical inspection
lines, each of which can consist of a maximum of 40 characters.
After entering data for the first prompt, the second prompt
appears.