Fluke Biomedical medTester 5000C - Manual (Page 236)

medTester 5000C
Operators Manual
15-8
Pretest Device Prompts
There are eight prompts for information that you can attach to test records.
After selecting the desired autosequence, the medTester 5000C prompts you
to enter device prompts. If you have some or all prompts turned off, the
autosequence still gives you the brief opportunity to enter device information
at the test’s initiation with the message:
1. OP CODE—This is the operator code for the person doing the
testing. This code can consist of a maximum of three characters
that can be entered from the medTester keyboard. An example of
an operator code could be a person’s initials or employee number.
The previous operator’s code, if any, will appear. If the current
operator has not changed from previous use, press the
ENT key.
2. TYPE—Enter the device name, code, or other descriptor for the
equipment under test. This entry can be a maximum of 16
characters.
3. MANF—Enter the name of the device manufacturer, 16
characters maximum.
4. LOC—Type in the location of the device, 16 characters
maximum. The previous location, if any, will appear. If this occurs
and is the desired location, press the
ENT key.
5. MODEL—Enter the device model number, 16 characters
maximum.
6. SERIAL #—Type the device serial number, again 16 characters
maximum.
7. CONTROL #—Enter a control number with a maximum of 16
characters.
8. PHYSICAL INSPECTION—You have two physical inspection
lines, each of which can consist of a maximum of 40 characters.
After entering data for the first prompt, the second prompt
appears.
Press F5 for all device info prompts