Fluke Biomedical medTester 5000C - Manual (Page 38)

medTester 5000C
Operators Manual
2-6
Note
If running Windows 95 or 98, with the mouse you can click and
hold the Start button, then select Programs and MS-DOS Prompt.
If running Windows 2000 or XP, with the mouse click the Start
button, select Programs, Accessories, and Comnmand Prompt.
7. Insert the diskette into the computer's 3.5" floppy disk drive.
8. At the DOS prompt type this command:
A:\INSTALL port baud
Where
A
is the floppy disk drive letter, A or B, and
port
is the computer COM port, 1 through 4, and
baud
is the selected baud rate: 300, 600, 1200, 2400, 4800, 9600,
or 19200.
Here’s an example of this command:
A:\INSTALL 1 9600
9. The program will install (enable) the module in the medTester.
The computer should display
MODULES SUCCESSFULLY
LOADED
.
Note: If you have problems or get a different message, you can
read the
README
file by typing A:
README
for
suggestions.
Modules are customized for each instrument and can only be
installed on the instrument with that specific serial number. Some
modules need prerequisite modules to be installed first.
MODULE PREREQUISITE REQUIREMENTS
Module Description Prerequisite
2 RS232 / Printer None
3 100 Record Storage Module 2
4 Expanded Record Storage Modules 2 & 3
5 Waveforms / Extended Testing Modules 2 & 3
6 Data Transfer Modules 2 & 3
7 MedCheck Modules 2, 3, & 4
8 DEFIB Autosequences Modules 2,3, & 4
9 IVPUMP Autosequences Modules 2,3, & 4
10 Competitive CMMS Interface Modules 2,3,4,6 &
7
11 ESU Autosequences Modules 2,3, & 4
12 SPO2 Autosequences Modules 2,3, & 4
13 PACER Autosequences Modules 2,3, & 4
14 NIBP Autosequences Modules 2,3, & 4