Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 99)

BIOS
ATCA-7470 Installation and Use (6806800P15K) 99
4.7.4 Security
O/S Watchdog Timeout
Action Do Nothing,
Reset (Default),
Power Down, Power Cycle Configure how the system should respond
when the Boot Watchdog expires.
Local SEL -- Press Enter to show the local System Event
Log (SEL)
FRU Information -- Press Enter to show the FRU information of
the board, the Acceleration Module and
the RTM.
Show Board Sensors -- Press Enter to show the state of the boards
voltage and temperature sensors.
Table 4-13 IPMI
Item Values Description
Table 4-14 Security
Item Values Description
Set Supervisor Password -- Press Enter to set or clear the Supervisor
password.
Supervisor Hint String -- Press Enter to type the Supervisor Hint
string.
Min. password length 1…20
1: Default Set the minimum number of characters for
the password.
HDD Password Select User Only (Default)
User + Master Supports user only or both user and master
password.
TPM Support Enable (Default)
Disable Enable/Disable TPM support.
TPM Action -- Enact TPM Action. Note: Most TPM actions
require TPM to be Enabled to take effect.
Omit Boot Measurement Enabled
Disabled (Default) Enabling this option causes the system to
omit recording boot device attempts in
PCR[4].