Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 92)

BIOS
ATCA-7470 Installation and Use (6806800P15K) 92
Procedure
To restore the BIOS default settings, proceed as follows:
1. Remove the blade from the system. See Installing and Removing the Blade on page 61 for
the exact procedure.
4.7 BIOS Setup Configuration
4.7.1 Main
Table 4-1 Main
Item Values Description
System Date [Thu 11/11/2010] Set the Date. Use Tab to switch between
Date elements
System Time [15:48:21] Set the Time. Use Tab to switch between
Time elements.
Table 4-2 Main -> Boot Configuration
Item Values Description
Front Panel Net Boot Enabled (Default),
Disabled Controls execution of the Option ROM for
the Front Panel Ethernet controller. Select
Enabled when Front Panel Boot is required.
Base Network Boot Enabled (Default),
Disabled Controls execution of the Option ROM for
both Base Network Ethernet controller.
Select Enabled when Base Network Boot is
required.
ARTM Network Boot Enabled,
Disabled (Default) Controls execution of the Option ROM for
RTM Network Ethernet controller. Select
Enabled when RTM Network Boot is
required.
ARTM SAS Boot Enabled (Default),
Disabled Controls execution of the Option ROM for
RTM SAS controller. Select Enabled when
RTM SAS Boot is required.