3 module identification register, 4 version register, 5 serial redirection control register – Artesyn ATCA-7470 Installation and Use (October 2014) User Manual
Page 153: Table 6-10, Module identification register, Table 6-11, Version register, Maps and registers
Maps and Registers
ATCA-7470 Installation and Use (6806800P15K)
153
6.4.3
Module Identification Register
The Module Identification Register identifies the ATCA-7470.
6.4.4
Version Register
The version register provides the version of the FPGA bit stream. The initial value starts at 0x06
with Revision B and is incremented with each new release.
6.4.5
Serial Redirection Control Register
BIOS sets the corresponding bit, which is used for serial redirection. The IPMC uses this
information to route the corresponding port to serial IPMC interface in case of SOL.
Table 6-10 Module Identification Register
Address Offset: 0x00
Bit
Description
Default
Access
7:0
ATCA-7470 Module Identification
0x70
r
Table 6-11 Version Register
Address Offset: 0x01
Bit
Description
Default
Access
7:0
Specifies FPGA version
0x6 (Initial Value)
r
BIOS should never set both status bits.