Hardware preparation and installation – Artesyn ATCA-7470 Installation and Use (October 2014) User Manual

Page 62

Text mode
Original mode

Hardware Preparation and Installation

ATCA-7470 Installation and Use (6806800P15K)

Installation Procedure

To install the blade into an AdvancedTCA shelf, proceed as follows.

1. Visually inspect the blade and backplane connectors for damage or bent pins before

attempting to insert a board. If any connector damage or pin damage in observed, stop
before inserting the blade and send the damaged item through proper repair channels.

2. Slide the latch into the release position and pull out the handle outward to unlatch the

handle from the face plate. Do not rotate the handle fully outward.

Latch

Handle

This manual is related to the following products:

ATCA-7470 Installation and Use (November 2014) ATCA-7470 Installation and Use (May 2014) ATCA-7475 Installation and Use (October 2014) ATCA-7475 Installation and Use (November 2014) ATCA-7475 Installation and Use (May 2014)