Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 59)

Hardware Preparation and Installation
ATCA-7470 Installation and Use (6806800P15K) 59
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 61 .
2. Plug the MO297 SSD module into the MO297 connector. When inserting the
MO297 module to the onboard connector, hold the onboard connector with two
fingers to prevent damage to the connector.
3. Fasten the MO297 SSD module to the blade using the screws supplied with the ACC
kit.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 61 .
The additional resource (either memory or SATA SSD) will be detected
automatically during the boot-up sequence.
Removal Procedure
To remove an MO297 SSD module, proceed as follows:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 61 .
2. Remove the two screws holding the MO297 SSD module .
3. Remove the MO297 SSD module from the blade.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 61 .
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.