Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 126)

Functional Description
ATCA-7470 Installation and Use (6806800P15K) 126
5.4.1 PCH I/O Controller Features
PCH I/O Controller features are as follows:
 X4 PCIe Gen1 (2.5GT/s) to Zone 3
 8237 DMA controller
 8254 based Counter Timer/timers
 8259 Interrupt Controllers PIC (D31:F0)
 I/O APIC controller (D31:F0)
 Serial Interrupt (D31:F0)
 RTC with 256-byte battery-backed SRAM (D31:F0) (D31:F7)
 Processor Interface (D31:F0) including Thermtrip input and A20GATE, INIT3_3V,
CPUPWRGD, PMSYNC#, PECI
 2 x COM 16550 compatible UART up to 115Kbit/sec: usable on Faceplate, RTM, Serial Over
LAN support (SMB Pass through)
 Two stage Watchdog timer (WDT) (D31:F7)
 SPI Interface (Boot Flash): up to two devices 20 + 33MHz
 LPC Interface
 Two serial ATA (SATA) controllers (D31:D2 for AHCI mode) and (D31:F5 Native IDE mode)
for up to 6 physical SATA ports
 Six USB 2.0 interfaces through one EHCI host controller (D29:F0)
 Power management support (D31:F0) including ACPI S3 state support (suspend to RAM)
S4 Suspend to disk) and G2/S5 state (SOFF) soft off as well as Power failure detection and
Management Engine Power Management support.
 High Precision Event Timers (HPET)
 System TCO (total cost of ownership) Reduction circuits
 SMBus Host controller (D31:F3) and SMLINK1 interface for access from external Host.
 General purpose I/O pins (D31:F0)