Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 70)

Controls, Indicators, and Connectors
ATCA-7470 Installation and Use (6806800P15K) 70
3.1.3.1 Serial COM#1 P17
Serial line interface #1 of Glue Logic FPGA is available at the faceplate of ATCA-7470. A female
RJ45 connector is used for serial line connection. Cisco-like Pinout according following table is
used. Additionally, Hardware Handshake support signals are available.
3.1.3.2 Ethernet Connector
There are two Ethernet connectors:
 ETH1 connector P70
 ETH2 connector P71
Table 3-2 RJ45 female Serial Line Connector pinout
Pin Signal
1 COM1_CTS
2 COM1_DTR
3 COM1_RS232_TXD
4 GND
5 GND
6 COM1_RS232_RXD
7 COM1_DSR
8 COM1_RTS