Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 19)

ATCA-7470 Installation and Use (6806800P15K) 19
About this Manual
Overview of Contents
This Reference Guide is intended for users qualified in electronics or electrical engineering.
Users must have a working understanding of Peripheral Component Interconnect (PCI),
AdvancedTCA®, and telecommunications.
The manual contains the following chapters and appendices:
 About this Manual on page 19 , lists all conventions and abbreviations used in this manual
and outlines the revision history.
 Safety Notes on page 25 , lists safety notes applicable to the blade.
 Sicherheitshinweise on page 29 , provides the German translation of the safety notes
section.
 Introduction on page 35 , describes the main features of the blade.
 Hardware Preparation and Installation on page 45 , outlines the installation requirements,
hardware accessories, switch settings, installation and removal procedures.
 Controls, Indicators, and Connectors on page 67 , describes external interfaces of the blade.
This includes connectors and LEDs.
 BIOS on page 83 , describes the features and setup of BIOS.
 Functional Description on page 123 , describes the functional blocks of the blade in detail.
This includes a block diagram, description of the main components used and so on.
 Maps and Registers on page 141 , provides information on the maps and registers of the
blade.
 Serial Over LAN on page 197 , provides information on how to establish a serial-over LAN
session on your blade.
 Boot Bank Selection on page 203 , provides information on BIOS Boot Bank Selection.
 Supported IPMI Commands on page 207 , lists all supported IPMI commands.
 FRU Information and Sensor Data Records on page 253 , provides information on the blade’s
FRU information and sensor data.
 Firmware Upgrade on page 271 , provides information on how to upgrade the firmware
components.