Artesyn ATCA-7470 Installation and Use (October 2014) User Manual

Page 202

Text mode
Original mode

Serial Over LAN

ATCA-7470 Installation and Use (6806800P15K)

202

6. Start ATCA-7470 SOL session on your target with the ipmitool and the configured

IP address for the ATCA-7470 SOL interface.
ipmitool -C 1 -I lanplus -H 172.16.0.221 -U soluser -P

solpasswd -k gkey sol activate
For details on the command parameters, refer to the ipmitool documentation
available on

http://ipmitool.sourceforge.net

To access BIOS setup screen, it is necessary to reset the payload. SOL session is only available
if the payload is powered on and initialized by the BIOS.

This manual is related to the following products:

ATCA-7470 Installation and Use (November 2014) ATCA-7470 Installation and Use (May 2014) ATCA-7475 Installation and Use (October 2014) ATCA-7475 Installation and Use (November 2014) ATCA-7475 Installation and Use (May 2014)