Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 225)

Supported IPMI Commands
ATCA-7470 Installation and Use (6806800P15K) 225
9.3 Artesyn Specific Commands
The Artesyn Embedded Technologies IPMC supports several commands which are not defined
in the IPMI or PICMG 3.0 specification but are introduced by Artesyn Embedded Technologies:
serial output commands.
9.3.1 Serial Output Commands
9.3.1.1 Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port
connector.
 Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Artesyn Embedded Technologies specific
IPMI commands by using the IPMI command 'Get Device ID'. Sending Artesyn specific
commands to IPMI controllers which do not support these IPMI commands will lead to
no or undefined results.
 Proper handling of these commands is required to write a portable application.
Table 9-19 Serial Output Commands
Command Name NetFn (Request/Response) CMD Description
Set Serial Output 0x2E/0x2F 0x15 See Set Serial Output Command on
page 225
Get Serial Output 0x2E/0x2F 0x16 See Get Serial Output Command on
page 227