Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 227)

Supported IPMI Commands
ATCA-7470 Installation and Use (6806800P15K) 227
9.3.1.2 Get Serial Output Command
The Get Serial Output Command provides a way to determine which serial output source goes
to a particular serial port connector.
9.3.1.2.1 Request Data
The following table lists the request data applicable to the Get Serial Output command.
9.3.1.2.2 Response Data
The following table lists the response data applicable to the Get Serial Output command.
Currently, only BIOS output is supported.
Table 9-22 Request Data of Get Serial Output Command
Byte Data Field
1 LSB of Artesyn IANA Enterprise number. A value of 0xCD has to be used.
2 Second byte of Artesyn IANA Enterprise number. A value of 0x65 has to be used.
3 MSB of Artesyn IANA Enterprise number. A value of 0x00 has to be used.
4 Serial connector type
0: Face plate connector
1: Backplane connector
All other values are reserved.
Note: Only the faceplate connector is supported. No connector on the RTM available.
5 Serial connector instance number. A sequential number that starts from 0.
Table 9-23 Response Data of Get Serial Output Command
Byte Data Field
1 Completion code