Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 229)

Supported IPMI Commands
ATCA-7470 Installation and Use (6806800P15K) 229
9.3.2.1 Set Feature Configuration
This command can be used to enable/disable features configurations within the IPMC during
runtime.
Table 9-25 Set Feature Configuration Command
Byte Data Field
Request Data 1 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be
used.
2 2nd byte of Artesyn IANA Enterprise Number. A value of 65h
shall be used.
3 MSB of Artesyn IANA Enterprise Number. A value of 00h shall
be used.
4 Feature Selector. For details, see Table "Feature Selector
Assignments" on page 230 .
5 Feature Configuration.
00h = disabled (Feature Selector = E0)
01h = enabled (Feature Selector = E0)
02h – FFh = reserved
6 Persistency / Duration
00h = volatile. Actual duration depends on implementation.
01h – FFh = reserved
Response Data 1 Completion Code. Generic plus the following command-
specific completion codes:
80h = feature selector not supported.
81h = feature configuration not supported
83h = configuration persistency / duration not supported
2 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be
used.
3 2nd byte of Artesyn IANA Enterprise Number. A value of 65h
shall be used.
4 MSB of Artesyn IANA Enterprise Number. A value of 00h shall
be used.