Artesyn ATCA-7470 Installation and Use (October 2014) - Manual (Page 98)

BIOS
ATCA-7470 Installation and Use (6806800P15K) 98
4.7.3 IPMI
UART2 to RTM Enable (Default)
Disable This option controls the UART2. When
enabled, ART2 uses address 2F8h and IRQ
3. UART2 is connected to the RTM.
Table 4-12 Advanced --> SMBIOS Event Log
Item Values Description
Event Log Enable (Default)
Disable Enable/Disable SMBIOS Event Logging.
View SMBIOS event log -- Press Enter to view the SMBIOS event log
Mark SMBIOS events as
read -- Press Enter to mark all SMBIOS events as
read. Marked events won't be displayed.
Clear SMBIOS events -- Press Enter to clear the SMBIOS event log
Table 4-11 Advanced --> Super IO Configuration
Item Values Description
Table 4-13 IPMI
Item Values Description
IPMI KCS Interrupt Enable
Disable (Default) Enable/Disable usage of Host Interface
(KCS) interrupt. KCS interrupt is hardwired
to IRQ 6
Clear Local System
EventLog Enable
Disable (Default) Clear all events in the local system event
log. The value will be reset to [Disabled]
after a reboot.
O/S Watchdog Timer Enable
Disable (Default) If enabled, starts the IPMI watchdog just
before booting the OS. The OS has to shut
off the watchdog timer when successfully
booted.
O/S Watchdog Timer
Timeout 1, 2, 3, 4, 7, 10, 15, 20
minutes
Default: 5 minutes Configure the Timeout of the O/S Boot
Watchdog Timer.