Altera DisplayPort MegaCore Function - Manual (Page 91)

Figure 7-2: Simulation Example Block Diagram for Arria V and Stratix V Devices
The files are named <prefix>_<name>.<extension> where <prefix> represents the device (av for Arria V
devices and sv for Stratix V devices).
rx_video_out
tx_video_in
Design Under Test
(_dp_example.v)
DisplayPort IP Core
(_dp.v)
VGA
Reconfiguration
Management
Transceiver
Reconfiguration
IP Core
tx_mgmt
clk100 clk16 clk162 clk270
tx_serial_data
rx_serial_data
tx_aux
rx_aux
tx_vid_clk rx_vid_clk
Native PHY IP Core
(_native_phy_tx.v)
Native PHY IP Core
(_native_phy_rx.v)
Design Walkthrough
Setting up and running the DisplayPort simulation example consists of the following steps:
1. Copy the simulation files to your target directory.
2. Generate the IP simulation files and scripts, and compile and simulate.
3. View the results.
You use a script to automate these steps.
Copy the Simulation Files to Your Working Directory
Copy the simulation example files to your working directory using the command:
cp -r
<IP root directory>
/altera/altera_dp/sim_example/
<device> <working directory>
where <device> is a10 for Arria 10 devices, av for Arria V devices, cv for Cyclone V devices, and sv for
Stratix V devices.
Your working directory should contain the files shown below.
UG-01131
2015.05.04
Design Walkthrough 7-3
DisplayPort IP Core Simulation Example Altera Corporation
Send Feedback