Altera DisplayPort MegaCore Function - Manual (Page 74)

TX PLL0
Selected reference clock source
0
Selected clock network
×1 or ×N
Note: If you select ×1, you must instantiate
the PHY instance multiple times for
all data channels as per maximum
lane count parameter. This value is
for non-bonded mode.
RX PMA
Enable CDR dynamic reconfiguration On
Number of CDR reference clocks
1
Selected CDR reference clock
0
Selected CDR reference clock frequency
135 MHz
PPM detector threshold
1000 ppm
Enable rx_is_lockedtodata port
On
Enable rx_is_lockedtoref port
On
Enable rx_set_locktodata and rx_set_locktoref ports
On
Standard PCS
Standard PCS protocol mode
Basic
Standard PCS/PMA interface width
20 (when symbol output mode is dual)
Byte Serializer and Deserializer
Enable TX byte serializer
Off (when symbol output mode is dual)
Enable RX byte deserializer
Off (when symbol output mode is dual)
Note: Currently, only Arria V GX, Arria V GZ, and Stratix V devices support 5.4 Gbps operation.
UG-01131
2015.05.04
Transceiver and Clocking 6-13
DisplayPort IP Core Hardware Demonstration Altera Corporation
Send Feedback