Cisco ASA 5505 - Manual (Page 874)

42-10
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 42 Getting Started with Application Layer Protocol Inspection
Configuring Application Layer Protocol Inspection
icmp error —
ils —
im [map_name] If you added an Instant Messaging inspection policy map
according to
“Configuring an Instant Messaging Inspection
Policy Map for Additional Inspection Control” section on
page 43-21
, identify the map name in this command.
ip-options [map_name] If you added an IP Options inspection policy map according
to
“Configuring an IP Options Inspection Policy Map for
Additional Inspection Control” section on page 43-25 ,
identify the map name in this command.
mgcp [map_name] If you added an MGCP inspection policy map according to
“Configuring an MGCP Inspection Policy Map for
Additional Inspection Control” section on page 44-13
,
identify the map name in this command.
netbios [map_name] If you added a NetBIOS inspection policy map according to
“Configuring a NetBIOS Inspection Policy Map for
Additional Inspection Control” section on page 43-29
,
identify the map name in this command.
pptp —
radius-accounting [map_name] The radius-accounting keyword is only available for a
management class map. See the
“Creating a Layer 3/4 Class
Map for Management Traffic” section on page 32-14 for
more information about creating a management class map.
If you added a RADIUS accounting inspection policy map
according to
“Configuring a RADIUS Inspection Policy
Map for Additional Inspection Control” section on
page 46-10
, identify the map name in this command.
rsh —
rtsp [map_name] If you added a RTSP inspection policy map according to
“Configuring an RTSP Inspection Policy Map for Additional
Inspection Control” section on page 44-16
, identify the map
name in this command.
sip [map_name] If you added a SIP inspection policy map according to
“Configuring a SIP Inspection Policy Map for Additional
Inspection Control” section on page 44-20
, identify the map
name in this command.
skinny [map_name] If you added a Skinny inspection policy map according to
“Configuring a Skinny (SCCP) Inspection Policy Map for
Additional Inspection Control” section on page 44-26
,
identify the map name in this command.
snmp [map_name] If you added an SNMP inspection policy map according to
“Configuring an SNMP Inspection Policy Map for
Additional Inspection Control” section on page 46-11
,
identify the map name in this command.
Table 42-2 Protocol Keywords
Keywords Notes