Adding an ethertype access list, Information about ethertype access lists, Licensing requirements for ethertype access lists – Cisco ASA 5505 User Manual
Page 395: C h a p t e r, Chapter 16, “adding an ethertype access list
C H A P T E R
16-1
Cisco ASA 5500 Series Configuration Guide using the CLI
16
Adding an EtherType Access List
This chapter describes how to configure EtherType access lists and includes the following sections:
•
Information About EtherType Access Lists, page 16-1
•
Licensing Requirements for EtherType Access Lists, page 16-1
•
Guidelines and Limitations, page 16-2
•
•
Configuring EtherType Access Lists, page 16-2
•
Monitoring EtherType Access Lists, page 16-4
•
•
Configuration Examples for EtherType Access Lists, page 16-5
•
Feature History for EtherType Access Lists, page 16-5
Information About EtherType Access Lists
An EtherType access list is made up of one or more Access Control Entries (ACEs) that specify an
EtherType. An EtherType rule controls any EtherType identified by a 16-bit hexadecimal number, as well
as other traffic types. See the
“Supported EtherTypes and Other Traffic” section on page 34-6
for more
information.
For information about creating an access rule with the EtherType access list, see
Licensing Requirements for EtherType Access Lists
The following table shows the licensing requirements for this feature:
Model
License Requirement
All models
Base License.