Cisco ASA 5505 - Manual (Page 401)

C H A P T E R
17-1
Cisco ASA 5500 Series Configuration Guide using the CLI
17
Adding a Standard Access List
This chapter describes how to configure a standard access list and includes the following sections:
• Information About Standard Access Lists, page 17-1
• Licensing Requirements for Standard Access Lists, page 17-1
• Guidelines and Limitations, page 17-1
• Default Settings, page 17-2
• Adding Standard Access Lists, page 17-3
• What to Do Next, page 17-4
• Monitoring Access Lists, page 17-4
• Configuration Examples for Standard Access Lists, page 17-4
• Feature History for Standard Access Lists, page 17-5
Information About Standard Access Lists
Standard access lists identify the destination IP addresses of OSPF routes and can be used in a route map
for OSPF redistribution. Standard access lists cannot be applied to interfaces to control traffic.
Licensing Requirements for Standard Access Lists
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature:
• Context Mode Guidelines, page 17-2
• Firewall Mode Guidelines, page 17-2
Model License Requirement
All models Base License.