Cisco ASA 5505 User Manual
Page 612
31-6
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 31 Configuring Twice NAT
Configuring Twice NAT
Step 5
(Optional)
object service
obj_name
service
{tcp | udp} destination
operator port
Example:
hostname(config)# object service REAL_SVC
hostname(config-service-object)# service
tcp destination eq 80
hostname(config)# object service
MAPPED_SVC
hostname(config-service-object)# service
tcp destination eq 8080
Configure service objects for:
•
Destination real port
•
Destination mapped port
Dynamic NAT does not support port translation. However,
because the destination translation is always static, you can
perform port translation for the destination port. A service object
can contain both a source and destination port, but only the
destination port is used in this case. If you specify the source port,
it will be ignored. NAT only supports TCP or UDP. When
translating a port, be sure the protocols in the real and mapped
service objects are identical (both TCP or both UDP). For identity
NAT, you can use the same service object for both the real and
mapped ports. The “not equal” (neq) operator is not supported.
Command
Purpose