Asa 5505) configuring basic network settings, Asa 5505) configuring basic – Cisco ASA 5505 User Manual
Page 1231
58-11
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 58 Configuring the ASA IPS Module
Configuring the ASA IPS module
Detailed Steps
(ASA 5505) Configuring Basic Network Settings
An ASA IPS module on the ASA 5505 does not have any external interfaces. You can configure a VLAN
to allow access to an internal IPS management IP address over the backplane. By default, VLAN 1 is
enabled for IPS management. You can only assign one VLAN as the management VLAN. This section
describes how to change the management VLAN and IP address if you do not want to use the default. It
also describes how to change the allowed hosts and gateway. See the
for more information about defaults.
Note
Perform this configuration on the ASA 5505, not on the ASA IPS module.
Prerequisites
When you change the IPS VLAN and management address from the default, be sure to also configure
the matching ASA VLAN and switch port(s) according to the procedures listed in
Interface Configuration (ASA 5505).”
You must define and configure the VLAN for the ASA so the IPS
management interface is accessible on the network.
Command
Purpose
Step 1
Session to the IPS module according to the
“Sessioning to the Module from the ASA”
section on page 58-9
.
Step 2
setup
Example:
sensor# setup
Runs the setup utility for initial configuration of the ASA IPS
module. You are prompted for basic settings.