Cisco ASA 5505 - Manual (Page 1025)

48-43
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 48 Configuring the Cisco Phone Proxy
Configuration Examples for the Phone Proxy
mGF/hfDDNAICBAA=
hostname(config)# quit
INFO: Import PKCS12 operation completed successfully
hostname(config)#
Step 3 Create the CTL file instance on the new ASA using the same name as the one used in the SAST
trustpoints created in
Step 2 by entering the following commands. Create trustpoints for each Cisco
UMC (primary and secondary).
hostname(config)# ctl-file ctl_name
hostname(config-ctl-file)# record-entry cucm trustpoint trust_point address address
hostname(config-ctl-file)# record-entry capf trustpoint trust_point address address
hostname(config-ctl-file)# no shutdown
Configuration Examples for the Phone Proxy
This section includes the following topics:
• Example 1: Nonsecure Cisco UCM cluster, Cisco UCM and TFTP Server on Publisher, page 48-43
• Example 2: Mixed-mode Cisco UCM cluster, Cisco UCM and TFTP Server on Publisher,
page 48-45
• Example 3: Mixed-mode Cisco UCM cluster, Cisco UCM and TFTP Server on Different Servers,
page 48-46
• Example 4: Mixed-mode Cisco UCM cluster, Primary Cisco UCM, Secondary and TFTP Server on
Different Servers, page 48-47
• Example 5: LSC Provisioning in Mixed-mode Cisco UCM cluster; Cisco UCM and TFTP Server on
Publisher, page 48-49
• Example 6: VLAN Transversal, page 48-51
Example 1: Nonsecure Cisco UCM cluster, Cisco UCM and TFTP Server on
Publisher
Figure 48-2 shows an example of the configuration for a non-secure Cisco UCM cluster using the
following topology.