Cisco ASA 5505 - Manual (Page 20)

Contents
xx
Cisco ASA 5500 Series Configuration Guide using the CLI
Defining a Network for an EIGRP Routing Process 27-5
Configuring Interfaces for EIGRP 27-6
Configuring Passive Interfaces 27-7
Configuring the Summary Aggregate Addresses on Interfaces 27-8
Changing the Interface Delay Value 27-9
Enabling EIGRP Authentication on an Interface 27-9
Defining an EIGRP Neighbor 27-10
Redistributing Routes Into EIGRP 27-11
Filtering Networks in EIGRP 27-12
Customizing the EIGRP Hello Interval and Hold Time 27-13
Disabling Automatic Route Summarization 27-14
Configuring Default Information in EIGRP 27-15
Disabling EIGRP Split Horizon 27-16
Restarting the EIGRP Process 27-17
Monitoring EIGRP 27-17
Configuration Example for EIGRP 27-18
Feature History for EIGRP 27-19
C H A P T E R
28 Configuring IPv6 Neighbor Discovery 28-1
Information About IPv6 Neighbor Discovery 28-1
Neighbor Solicitation Messages 28-2
Neighbor Reachable Time 28-3
Router Advertisement Messages 28-3
Static IPv6 Neighbors 28-4
Licensing Requirements for IPv6 Neighbor Discovery 28-4
Guidelines and Limitations 28-4
Default Settings for IPv6 Neighbor Discovery 28-6
Configuring the Neighbor Solicitation Message Interval 28-7
Configuring the Neighbor Reachable Time 28-7
Configuring the Router Advertisement Transmission Interval 28-8
Configuring the Router Lifetime Value 28-8
Configuring DAD Settings 28-9
Configuring IPv6 Addresses on an Interface 28-9
Suppressing Router Advertisement Messages 28-10
Configuring the IPv6 Prefix 28-11
Configuring a Static IPv6 Neighbor 28-12
Monitoring IPv6 Neighbor Discovery 28-13