Cisco ASA 5505 - Manual (Page 1256)

59-10
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 59 Configuring the ASA CX Module
Configuring the ASA CX Module
What to Do Next
• (Optional) Configure the authentication proxy port. See the “(Optional) Configuring the
Authentication Proxy Port” section on page 59-10 .
• Divert traffic to the ASA CX module. See the “Redirecting Traffic to the ASA CX Module” section
on page 59-11 .
(Optional) Configuring the Authentication Proxy Port
The default authentication port is 885. To change the authentication proxy port, perform the following
steps. For more information about the authentication proxy, see the
“Information About Authentication
Proxy” section on page 59-3 .
Note You can also set the port as part of the ASDM startup wizard. See the “Configuring Basic ASA CX
Settings at the ASA CX CLI” section on page 59-7 .
Detailed Steps
Command Purpose
cxsc auth-proxy port port
Example:
hostname(config)# cxsc auth-proxy port 5000
Sets the authentication proxy port greater than 1024. The default
is 885.