Cisco ASA 5505 - Manual (Page 485)

25-5
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 25 Configuring RIP
Customizing RIP
Configuring the RIP Version
To specify the version of RIP used by the ASA, perform the following steps:
Detailed Steps
Command Purpose
Step 1 router rip
Example:
hostname(config)# router rip
Starts the RIP routing process and places you in router
configuration mode.
Step 2 network network_address
Example:
hostname(config)# router rip
hostname(config-router)# network 10.0.0.0
Specifies the interfaces that will participate in the RIP routing
process.
If an interface belongs to a network defined by this command, the
interface will participate in the RIP routing process. If an
interface does not belong to a network defined by this command,
the interface will not send or receive RIP updates.
Step 3 Enter one of the following numbers to customize an interface to participate in RIP routing:
version [1 | 2]
Example:
hostname(config-router):# version [1]
Specifies the version of RIP used by the ASA.
You can override this setting on a per-interface basis.
In this example, Version 1 is entered.