Installing ultramaster, Installing ultra master – Rockwell Automation 1398-DDM-xxx USE MNL/ULTRA 200 DIG.SERVO.DR User Manual
Page 40
Publication 1398-5.0 – October 1998
3-2
ULTRA Master Installation
Installing ULTRA Master
To install ULTRA Master software on a hard drive:
1. Make a backup copy of the ULTRA Master disk in one of the fol-
lowing ways:
• Copy the ULTRA Master disk using the disk menu in the
Windows File Manager.
• If your computer has only one floppy disk drive, type from
the DOS command line prompt
diskcopy a: b:
and then
press
ENTER
. The software will prompt you when to insert the
SOURCE (ULTRA Master) disk and when to insert the TAR-
GET (blank) disk.
2. If Windows is not running, type
win
at the DOS prompt (
C:>
).
If Windows is already running, close any open applications.
3. Insert the ULTRA Master disk into a 1.44MB floppy disk drive,
typically drive A:, and close the drive door.
4. Choose
Run
, from the File menu in Windows Program Manager.
5. Type
a:setup
and then press
ENTER
. A message box will appear
saying that the setup is initializing. The message box may be
present for up to 40 seconds, depending on the speed of the PC.
6. A dialog box requires you to confirm whether or not
ULTRA Master should be installed on the hard drive (C: drive) of
the PC.
• To install ULTRA Master, choose
C
ontinue
, or press
ENTER
,
and continue with the next step.
• To stop the installation, choose
E
xit
. You are returned to Win-
dows.
7. Setup then asks where you would like to install ULTRA Master.
• To accept the path that Setup proposes in the
Path:
box
(c:\ultramst\...), choose
C
ontinue,
• To choose another directory, type a new path in the
Path:
box,
and then choose
C
ontinue
. You will not have the opportunity
to confirm your entry so type carefully.
• To return to the initial Setup window, choose
B
ack
.
• To stop the installation, choose
E
xit
. You will return to Win-
dows.
• To obtain on-line help with the installation, Choose
H
elp
.
8. A status bar will keep you informed of the installation progress.
When Setup is complete, choose
OK
or press
ENTER
to return to
Windows.