Rockwell Automation 1398-DDM-xxx USE MNL/ULTRA 200 DIG.SERVO.DR - Manual (Page 114)

Publication 1398-5.0 – October 1998
7-4 Power Connections
Y-Series Power Cables
Y-Series motors have a short “pigtail” cable which connects to the
motor but is not shielded. The motor power cables have a 6 inch shield
termination wire with a ring lug which should be connected to the
closest earth ground. This shield termination may be extended to the
full length of the motor pigtail if necessary, but it is best to connect the
supplied wire directly to ground without lengthening.
Figure 7.2 Pigtail Ground
Intro
6” Shield Termination
Motor Power Cable Connectors
Pigtail Cable
Motor
!
Intro
ATTENTION: High voltage may be present on the ter-
minals of the ULTRA 200 Series drive. Remove power and
disconnect the power cable before making or removing any
connection.
!
Intro
ATTENTION: Do not tin (solder) the exposed leads on
cables. Solder contracts over time and may loosen the
connection.