JLG 70H Parts Manual - Manual (Page 273)

3120290 2-195
SECTION 2 TURNTABLE
S
E
C
T
I
O
N
2
T
U
R
N
T
A
B
L
E
FIGURE 2-45. ELECTRICAL COMPONENTS INSTALLATION (TURNTABLE MOUNTED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.
ELECTRICAL COMPONENTS INSTALLATION (TURN-
TABLE MOUNTED)
Ref.
0236629
HORIZONTAL CUTOUT LIMIT SWITCH
INSTALLATION (STANDARD)
Ref. 4
1 4360057 Switch, Limit 1
2 4761000 Lockwasher #10 2
3 0721014 Bolt #10-24NC x 1 3/4” 2
4 Not Used
5 0200048 Arm, Actuator 1
6 4460049 Connector, Strain Relief 1
0236632
TILT INDICATOR INSTALLATION (STANDARD -
PRIOR TO JULY 1989)
Ref. -
0238734
TILT INDICATOR INSTALLATION (STANDARD - JULY
1989 TO PRESENT)
Ref. C
101 4360171 Indicator, Tilt 1
102 Hardware Options: A/R
0641406 Bolt 1/4”-20NC x 3/4” (Prior to July 1989) 4
4350106 Stud, Grooved (July 1989 to Present) 2
103 4761400 Lockwasher 1/4” (Prior to July 1989) 6
104 3311401 Nut 1/4”-20NC (Prior to July 1989) 6
105 3508393 Plate, Mounting (Prior to July 1989) 1
106 4300032 Stud (Welded on Part) (Prior to July 1989) 2
107 4751500 Flatwasher 5/16” (Prior to July 1989) 2
108 4751400 Flatwasher 1/4” (Prior to July 1989) 2
ALARMS INSTALLATION (OPTIONAL ON STAN-
DARD MACHINES BUILT PRIOR TO APRIL 1992)
Ref.
0237054 BACK-UP ALARM Ref. B
0237056 DESCENT ALARM Ref. B
0239055 MOTION ALARM Ref. A
0237055 TILT ALARM Ref. B
0237012 TRAVEL ALARM Ref. A
201 Not Used
202 Not Used
203 Alarm Options: 1
See Note Alarm (Used Prior to July 1989)
0140024 Alarm (Used July 1989 to April 1992)
Note: Use 0140024 Alarm in place of original
equipment 0140012 Alarm (No cover required
with 0140024 alarm)
0140024 Alarm (July 1989 to April 1992)
204 4300031 Stud (Welded on Part) 4
205 4751400 Flatwasher 1/4” 4
206 4761400 Lockwasher 1/4” 4