Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 97)

Xerox 4595 Copier/Printer System Administration Guide 5-7
5. Using the Scan Service
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
– SMTP Server - Server Name
Enter if
Specify by the Server Name
has been
selected for
SMTP Server - Setup
.
– SMTP Server - Port Number
Enter a value in the range from 1 to 65535.
NOTE: This configuration is not necessary if SMTP has
been selected for the Mail Receiving Protocol and has
already been configured.
– E-mail Send Authentication
Select one from
Off
,
POP before SMTP
, or
SMTP
AUTH
.
NOTE: If POP before SMTP has been selected, the POP3
settings must be set.
–
SMTP AUTH - Login Name
Set this item if
SMTP AUTH
has been selected for
E-
mail Send Authentication
.
– SMTP AUTH - Password
Set this item if
SMTP AUTH
has been selected for
E-
mail Send Authentication
. Enter the same password
twice in the
New Password
and
Confirm
Password
. If you do not wish to set the password,
leave it blank and select
Save
.
• Select
Close
.