Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 84)

Xerox 4595 Copier/Printer System Administration Guide 4-4
4. E-mail
2. Enable the ports which are used for the e-mail feature.
a. Select
System Settings
b. Select
Network Settings
.
c. Select
Port Settings
.
d. Enable
Send E-Mail - Port
setting to use mail print.
e. Enable
Receive E-Mail - Port
setting to use mail print.
f. Enable
Mail Notice - Port
to use mail notice or job
completion notice.
g. Select
Close
repeatedly until the
Network Settings
screen is displayed.
3. Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select
Close
repeatedly until the
Network Settings
screen is displayed.
b. Select
Protocol Settings
.
c. Select
TCP/IP - Get IP Address
and select
Change
Settings
.
d. Select one from
DHCP
,
BOOTP
,
RARP
,
DHCP/Autonet
or
Manual
. If you select anything other than
Manual
, proceed
to step 4.
NOTE: When using a DHCP server, also configure the
WINS (Windows Internet Name Service) server.
e. Select
TCP/IP - Get IP Address
and select
Change
Settings
.
f. Enter the IP address using the numeric keypad.