Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 42)

Xerox 4595 Copier/Printer System Administration Guide 2-8
2. Configuration
h. Configure
TCP/IP - Subnet Mask
and
TCP/IP - Gateway
Address
as shown above.
NOTE 1: Enter addresses in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0 to
255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx
cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However, you
cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address, enter
"0.0.0.0."
4. Select
Close
repeatedly until the
System Settings
screen is
displayed.
5. Select
Exit
.
6. After the machine is restarted, print out the
Printer Settings
List
to confirm that the SMB port is enabled.
NOTE: If using the NetBEUI protocol, select NetBEUI as the
protocol used by SMB for the port configuration using CentreWare
Internet Services.
Configure the SMB as necessary. Refer to “SMB” on page 3-8 for
the SMB configuration.